Remote
The Galaxy 5000 supports the whole of the MGE UPS SYSTEMS remote management system to:
*

provide information on the UPS and its environment
*

controlled shutdown of the operating systems if genset has a malfunction at the time of black out.
Telecommunications:
24 X 7 continuity of service
*

with built in network cards, it can connect to internet for remote supervision
*

it is easily identified by the Enterprise Power Management UPS system supervisor.
Advantages
*

compatible with all types of loads: Leading power factor computer loads, high crest factor loads.
*

fully compatible with generator sets: Apart from high input power factor of the UPS it has a soft start so that a 60kVA UPS only requires a 66kVA* generator set (ignoring others loads supported by genset)
*

securing data with clean server shutdown
*

real time information about UPS status
View Product Specification Order

Best in High Availability power solutions
*

Tried and tested on-line double conversion design with dual source (automatic or manual switching), with quality output waveform (output voltage harmonic distortion less than 2% - THDU) and stable frequency.
Innovation UPS switching technology: IGBT Sixpacks
*

IGBT technology provides cleaner waveforms. The IGBT Sixpack semiconductors used in the Galaxy 5000 are most compact and themost integrated on the market.
Clean, stable output waveform
*

The output voltage from an on-line double conversion UPS is always generated internally, isolating it completely from mains disturbances.
THDI, <3%: supply cost savings and low pollution

The Galaxy 5000 IGBT AC/DC rectifier with power factor correction also uses a Sixpack:
*

very low input current totla harmonic distortion
*

power factor close to unity, even at low loads
Digibat Battery Monitoring: microprocessor based battery management.


DigiBat monitors the power levels, temperature, age and type of battery to adjust the battery charging voltage to surrounding temperture and continuously calculates:
*

the real backup time available.
*

the remaining life expectancy.

DigiBat also:
*

tests the battery system automatically (at intervals that can be pre-set), without affecting the battery capacity.
*

sounds an alarm if any problem is likely to occur.

The optional B1000 or Cellwatch battery monitoring systems monitor the battery systems 24 hours a day and provide predictive fault alarms per each block or cell:
*

continuous voltage measurement for each block or cell
*

continuous internal resistance measurement
*

identification of faulty blocks or cells (trend curves)
*

possibility of replacing individual blocks or cells
*

remote transfer of all data by Ethernet, current loop or J-bus